Wayona Nylon Braided USB Data Sync & 3A Charging Cable for iPhones, iPad Air, iPad Mini, iPod Nano and iPod Touch (3 FT Pack of 1, Grey)
Premium Nylon Braided Cable
iPhone 11 11Pro Pro Max iPhone Xs Max Xs X, iPhone 8 Plus, iPhone 8, iPhone 7 Plus, iPhone 7, iPhone 6s, iPhone 6, iPhone 6s Plus, iPhone 6 Plus, iPhone SE, iPhone 5S, iPhone 5, iPad Air / Air 2, iPad mini / mini 2 / mini 3, iPod nano (7th generation), and iPod touch (5th generation)
A first for USB charging cables, Wayona iPhone Compatible cord is reinforced with armored fiber. That makes it much stronger than conventional cables.
Heavy Duty for Heavy Use
We’ve reinforced this wire with high tensile fiber-a first for a USB charging cable. We’ve bent this cable over 5000 times and observed no damage or change in performance.
Faster Charging with Data transfer
With wide-diameter wires and reduced cord resistance, Cable provides data transfer and the fastest charging speed any USB charger is capable of.
Supports Fast Charging
FREQUENTLY ASKED QUESTIONS:
Q1: Does it charge fast ?
A1: Yes, it charges quickly with the 2.4A (max) current.
Q2. Does it support data transfer ?
A2: Sure, syncing is very well and fast.
Q3: Will it work with phone with cases ?
A3: The ultra-compact connector is slim enough to perfectly fit for most of cases.
Unmatched Cable Strength
Q: Why does the phone get hot when it’s charging?
A: This is normal, because the phone will generate some heat when it is charging. However, the main reasons for the heat are as follows:
1. The charging speed will be faster when the phone power is low, the wall charger will high current, and the phone will generate heat because of the voltage converting process.
2. There are too many programs running in the background of the phone, causing the phone to run at a high load and generate more heat.
1. Clean up the running program of the phone with high power consumption in the background in time.
2. Don’t play the phone while the phone is charged with low power, otherwise the phone will be in a high load state.
About the error message “This accessory may not be supported by device”:
The message would appear if you were using a non-Apple wall charger or in poor contact, but even if you are using an Apple accessory, the error can also happen for the firmware problem with iOS.
After analysis, the causes of this problem may be the following:
Device charging port contains impurities such as fiber and debris, resulting in poor contact.
The voltage of the wall charger is too low or unstable, resulting in insufficient power supply.
The charging end is corroded/stained, resulting in poor contact.
Circuit logic problems/system problems with charging equipment.
The chip or main board of the cable is damaged.
You can try the following solutions:
You can use a pushpin to clean out the pocket lint or debris from the charging port.
Wipe the charging end with a tissue to remove dirt and oxidation marks on the charging end.
If it still can’t fix the problem, please find us, we will solve your problems ASAP.[Fast Charge&Data Sync ] : It can charge and sync simultaneously at a rapid speed, Compatible with any charging adaptor, multi-port charging station or power bank.
[Durability] : Durable nylon braided design with premium aluminum housing and toughened nylon fiber wound tightly around the cord lending it superior durability and adding a bit to its flexibility.
[High Security Level ] : It is designed to fully protect your device from damaging excessive current.Copper core thick+Multilayer shielding, Anti-interference, Protective circuit equipment.
[WARRANTY] 12-months warranty and friendly customer services, ensures the long-time enjoyment of your purchase. If you meet any question or problem, please don’t hesitate to contact us.
Disclaimer: Competentauthoritydelhi.co.in is a participant in the Shop Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Sellers.